Affordable, Highly Mobile Power
The MLG8K diesel generator provides just the right combination of output, portability, ruggedness, efficiency and affordability for on-the-go, single smaller-load, single phase power needs.
Generac Mobile recognizes environmental responsibility and continues to meet emission regulations with the addition of our Interim & Tier 4 Generator line. The MLG8K generator is powered by a Kubota diesel engine. Proven power you can trust, while maximizing fuel efficiency and high performance
Tough And Durable
- Full tubular steel frame, lockable enclosure
- Durable, fade resistant, baked on white powder coat finish
- Stainless steel hinges, exterior hardware and pad lockable door latches
Proven Reliability
- Key switch to preheat (glow plug), start & stop
- Automatic low oil level / high temp shutdown alerts
- 40A main breaker
- 2 year - 2,000 hour warranty
- Marathon voltage regulation within +/- 1%
Easy To Use
- Self-priming 3 cylinder Kubota engine
- External convenience outlets with individual breakers
- External emergency stop switch
Standard Features - Engine System
- Isolated Mounted Engine Supports
- Paper Element Air Filter with Safety Cartridge
- Fixed Speed Fan Drive
- Spin On Cartridge Oil Filter
- Level 1 Fan and Belt Guards
- Oil Drain Extension
- Factory Filled Oil and Coolant
- 440 CCA Wet Cell Battery
Standard Features - Cooling System
- Capable of Operating at 120 °F (49 °C) Ambient
- Oil Filter: Spin-On Cartridge, Full Flow
- 50/50 Coolant (Ethylene Glycol)
- Factory Installed Radiator
- UV/Ozone Resistant Hoses
- Closed Coolant Recovery System
Standard Features - Fuel System
- Fuel Tank Capacity – gal (L): Total: 56.0 (212), Usable: 55.8 (212)
- Fuel Cap with Lanyard
- Primary and Secondary Fuel Filters
- Fuel Level Gauge
Standard Features - Control System
- 40 A Start Limit Breaker – Ensures No Load Condition Exists Before Starting
- Engraved Aluminum Punched and Anodized Control Panel
- Key Activated Switch with Four Positions (Glow Plugs, Off, Run, Start)
- Hour Meter
- Automatic Shutdown for High Coolant Temperature and Low Oil Pressure
Standard Features - Generator System
- Brushless Excitation
- 2/3 Pitch
- Four Pole
- Class F Insulation
- Sealed Bearing
- Full Load Capacity Alternator
Standard Features - Power Distribution
- Convenience Receptacles with Individual Breakers: (2) 120 V, 20 A, GFCI, Duplex (NEMA 5-20R), (1) 240 V, 30 A, Twistlock (NEMA L6-30R)
Standard Features - Enclosure
- White Polyester Powder Paint (UV and Fade Resistant and High Temperature Cured)
- Fully Lockable Enclosure
- Exterior Emergency Stop Switch
- Multi Lingual Operating and Safety Decals
- Document Holder with Owner’s Manual – Includes AC and DC Wiring Diagrams
- License Plate Holder with Light
- Stainless Steel Hinges, Door Latches, and Exterior Hardware
Standard Features - Trailer
- DOT Approved Tail, Side, Brake, and Directional Lights; Recessed Rear Lights
- Illuminated License Plate
- Transportation Tie Downs
- Safety Chains with Spring Loaded Safety Hooks
- 2 in (50.8 mm) Ball Hitch
- Single Axle 2,200 lb (998 kg) Leaf Spring
- 2,000 lb (907 kg) Tongue Jack with Footplate
- 13 in (330 mm) Tires
- ST175/80D13 Tubeless Tires 6 ply
- Single Wall Polyethylene Fenders
- 48 in (1,219 mm) Track Width
- Plug Adapter Flat 4
Standard Features - Warranty
- 2 Years, 2,000 Hours (Unlimited Hours Covered in First Year
Engine Specifications - General
- Make: Kubota D1105-E3BG
- EPA Emissions Compliance: Tier IV Final
- Aftertreatment System: None
- Cylinder #: 3
- Type: In Line
- Displacement: 68.5 in³ (1.2 L)
- Bore-in (mm): 3.27 (83)
- Stroke - in (mm): 3.64 (92.4)
- Compression Ratio: 17.6:1
- Intake Air Method: Naturally Aspirated
Engine Specifications - Engine Governing
- Governor: Mechanical
- Frequency Regulation (Steady State): <5%
Engine Specifications - Lubrication System
- Oil Pump Type: Trochoid
- Oil Filter Type: Spin-On Cartridge
- Crankcase Capacity - qts (L): 3.5 (3.3)
Engine Specifications - Cooling System
- Cooling System Type: Water Jacket
- Water Pump Type: Belt Driven
- Fan Type: Pusher
- Fan Speed - rpm: 1,800
- Fan Diameter - in (mm): 12.99 (330)
- Cooling System Capacity - qt (L): 4.5 (4.2)
Engine Specifications - Fuel System
- Fuel Type: Ultra Low Sulfur Diesel
- Fuel: ASTM Diesel Fuel Oil No.2 (JIS K2204 Gas Oil Specification No.2 or 3)
- Fuel Pump Type: Gear
- Injector Type: Direct Injection
- Engine Type: Direct Injection
- Fuel Supply Line Diameter - in (mm): 0.313 (7.9)
- Fuel Return Line Diameter - in (mm): 0.313 (7.9)
Engine Specifications - Engine Electrical System
- System Voltage: 12 VDC
- Battery Charger Alternator: 60 A
- Battery Size: 440 CCA
- Ground Polarity: Negative (-)
Additional information
| ENGINE | Displacement 38.5 cu. in. (1.2 L) |
|---|---|
| DIMENSIONS | Length 105 in. (2.67 m) Width 56 in. (1.42 m) Height 68 in. (1.73 m) Weight 1,030 lb. (467 kg) |
| OTHER | Fuel Tank Capacity 56.0 gal. (212 L) Run Time 80 hr |





